I did make sure the Quartus tool was set Enabled for Evaluation Mode. Is there a specific section you would have me see and follow instructions on? pdf for this downloaded and I have referenced it. I follow these instructions again and I still get the same error code (vsim-3033) I listed above when trying to run a simulation in ModelSim.Īlso the second link included here is busted/broken. I tried this method before and it did not work. The error that comes up when I am trying to simulate. It sounds like the suggestion here is to totally disable the simulation, you know, to get the error to go away. On the Simulation page of the Settings dialog box, change the Tool name option to. Select the category EDA Tool Settings and the subcategory Simulation. " To avoid this error, disable the EDA simulation tool in your project by opening the Settings dialog box from the Quartus II Assignments menu. I had found this link during my troubleshooting. Regarding the first link you included with your message. ***If it is possible to simulate this FFT (altera_fft_ii) IP from the IP catalog seen in Quartus Prime Lite, before buying it or paying any money, please let me know some good detailed instructions on how I can accomplish this simulation. If I can program the encrypted core to a platform before paying $$$$, is it possible for me to obtain simulation results as well (before paying $$$$)? I have seen in some other forums and links where it is stated that the core can be evaluated so long as the USB programmer cable is continually inserted to the platform board (inconvenient - pay money to remove).
#Modelsim altera lite license#
Obviously I need to have a license to use the FFT IP/core, but here is my question. Remove the unlicensed cores.Ģ04009 Can't generate netlist output files because the license for encrypted file "C." is not available.
#Modelsim altera lite plus#
The following errors are reported:Ģ04012 Can't generate netlist output files because the file "C." is an OpenCore Plus time-limited file. Looking back over in the Quartus Prime Lite tool, I see my design almost fully compiles, passing Synthesis, Place & Route, Assembler, Timing Analysis, but then fails at the EDA Netlist Writer causing the compilation to fail. This error was seen for each instantiation of the FFT IP(s) in my firmware design. Instantiation of 'auk_dspip_r22sdf_top' failed. for this price, after my simulation attempts with ModelSim-Altera returned Error: (vsim-3033). I discovered that it is available from ARROW, Mouser, et al. It appears that the FFT IP 'available' in Quartus Prime Lite (18.1) actually costs ~$8k.
0 kommentar(er)
